Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Burbank, CA
Chimney repair in Burbank usually starts because someone sees a crack, smells smoke in a room that isn’t the living room, or gets a sweep report that flags a damaged flue. Most of the homes we work on were built between 1920 and 1955, and their original clay tile liners have been through decades of earthquakes, wet winters, and long dry summers. Tidewater Chimney Sweep handles the repair, the relining, and the rebuild after the diagnosis, and we carry the contractor-grade materials to do it right. Call (866) 282-7014 if you suspect a problem or you’ve just had a report that worries you.
Why Burbank Homes Are Different
Burbank’s chimney work is dominated by the 1920s-1950s California bungalows and Spanish Colonial Revival homes in the Magnolia Park and Rancho districts, where original clay flues and brick masonry fireplaces were built decades before modern earthquake bracing codes. A standard cleaning here often turns into an inspection of cracked flue tiles and unstrapped masonry, because the housing stock is old enough that the chimney itself is usually the weak point, not the creosote. You see this in the numbered-street grid off Magnolia Boulevard and in the ranch homes near the Rancho Equestrian area: original brick fireboxes, clay tile liners, and mortar joints that have softened after eighty years of temperature swings.
The climate also shapes the work. Burbank has a warm, dry Mediterranean pattern with hot summers and mild winters, so wood-burning is seasonal and light. That means heavy creosote buildup is uncommon, but long disused fireplaces become nesting spots for birds, squirrels, and leaves. Then a Santa Ana wind event arrives and the homeowner lights a fire for the first time in November, and suddenly an obstructed flue matters. In Burbank, we’re less often digging out thick glaze and more often clearing debris, then checking whether the disuse hid a structural issue that’s been waiting.
One more thing: many Burbank homes sit in earthquake country with chimneys that were never strapped or reinforced to current standards. A cracked flue here is not always about fires, it’s often about ground movement over seventy years, and that’s a repair question, not a cleaning question.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Main Burbank Services
Most Burbank homeowners call us first for one of two things: a chimney sweep, or a dryer vent cleaning. Here’s what each looks like in this city.
Chimney Sweep in Burbank
A Chimney Sweep in Burbank in these older homes is part cleaning and part inspection. We remove the season’s debris, inspect the flue with a camera, and go over the firebox and masonry because original clay liners from the 1930s and 1940s crack in ways newer liners don’t. In Magnolia Park, a technician routinely finds hairline cracks in the original flue tiles and a bare-brick firebox someone painted years ago. We document everything so you know whether the chimney can wait, needs monitoring, or needs a repair before the next fire.
Dryer Vent Cleaning in Burbank
Dryer Vent Cleaning in Burbank matters in this city because many laundry rooms are interior closets with long, angled vent runs that collect lint faster than a short run out the back wall. Older bungalows and ranch homes often have vent lines installed decades ago that were never cleaned. A clogged dryer vent is a fire hazard that doesn’t announce itself until drying times double or the laundry room gets hot. We clean the full run and recommend redirecting or replacing ducting when the original install is wrong.
Chimney Repair in Burbank
Chimney repair in Burbank usually means one of two realities: a chimney that’s been damaged by decades of earthquake movement, or a chimney that’s simply old and leaking. Homes in the 91501, 91502, 91523, and 91526 ZIP codes were largely built before modern seismic bracing was required, and the original clay flue tiles crack, mortar joints fail, and brick faces spall. We do the full range of Chimney Repair work here, from crown rebuilds to full relining, all under one roof.
Here are the repairs we handle most in Burbank’s older housing stock.
Chimney Cap Installation
Signs you need it
You hear animal noise from the flue, see leaf debris at the firebox, or find water stains running down the interior brick face after rain.
What it costs in Burbank
A new chimney cap install in Burbank typically falls between $300 and $650, depending on flue size, roof access, and whether a custom stainless cap is needed.
How we do it
We measure the flue opening, select a stainless cap sized for your crown and liner, set it with mechanical fasteners, and confirm it’s level and sealed.
Chimney Flashing Repair
Signs you need it
Water staining on the ceiling near the chimney chase, peeling paint or efflorescence on the chimney breast, or damp drywall in the attic.
What it costs in Burbank
Flashing repair in Burbank runs about $400 to $900 for a single chimney line, more when old tar and counterflashing have to be fully removed and reworked.
How we do it
We cut back the existing material, inspect the step flashing and counterflashing, install new metal in a layered pattern, and seal every joint so water runs away from the flue rather than into the attic.
Chimney Crown Repair
Signs you need it
A cracked, spalling, or crumbling cement crown at the chimney top, often visible from the ground or from the street with binoculars.
What it costs in Burbank
Crown repair or a poured replacement crown in Burbank typically runs $800 to $1,700, depending on chimney size and whether demolition of the old crown is needed.
How we do it
We remove the damaged surface material, build or recast the crown with a proper slope and drip edge, and correct the wash angle so water sheds away from the flue.
Chimney Liner Installation
Signs you need it
A camera inspection shows cracked, separated, or missing sections of clay flue tile, especially in original 1930s and 1940s chimneys in Magnolia Park and the Rancho district.
What it costs in Burbank
A new stainless liner install in Burbank runs from $1,800 to $3,400, with the higher end covering longer runs, second-floor roof access, or a chimney with a hearth extension.
How we do it
We size the correct stainless liner, run it down the full flue length, insulate as required, and terminate it with the right cap and top plate for your chimney.
What Chimney Repair Costs in Burbank
| Item | Typical range in Burbank |
|---|---|
| Chimney cap installation | $300 – $650 |
| Chimney flashing repair | $400 – $900 |
| Chimney crown repair | $800 – $1,700 |
These are for typical single-story Burbank bungalows and two-story Spanish Revival homes. Roof access, chase height, and damage depth move the number up.
Is every cracked flue tile an emergency?
No. Hairline cracks in old clay liners are common in Burbank’s 1920s-1950s homes and many can be monitored. But gaps, offset tiles, or missing sections are different, and if you burn regularly, the flue should be lined before next season. Call (866) 282-7014 and we’ll tell you what the camera showed and whether you can wait.
Can you repair a chimney without taking it down?
In most Burbank homes, yes. We reline from the top, rebuild crowns in place, and replace flashing without pulling down the brick face. Full teardown is rare and only when the masonry itself is beyond saving. A camera inspection is what tells us which path you’re on.
Brands We Service in Burbank
We don’t stock retail-grade chimney parts in Burbank. We carry professional trade lines like DuraFlex liners and HeatShield restoration materials, plus Gelco and Olympia Chimney caps and terminations. Most repair parts are on our truck or sourced locally within a few days. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Burbank, CA
| Service | Typical range in Burbank |
|---|---|
| Chimney cap installation | $300 – $650 |
| Chimney cap replacement | $350 – $700 |
| Chimney liner installation | $1,800 – $3,400 |
| Chimney flashing repair | $400 – $900 |
| Chimney crown repair | $800 – $1,700 |
| Fireplace damper replacement | $250 – $600 |
| Chimney liner repair | $900 – $2,000 |
| Chimney repointing | $750 – $1,800 |
What moves the price up in Burbank is usually roof access on a two-story Spanish Revival, original clay tile that has to be broken out, or a chimney that hasn’t been inspected in twenty years and has more than one failure. We give a flat price before work starts, so the number we quote is the number you pay.
Neighborhoods We Serve in Burbank
We work across Burbank’s older housing stock, from the bungalows off Magnolia Boulevard to the ranch homes near the equestrian district. Most jobs we reach within a day or two.
- Magnolia Park
- Rancho Equestrian
- The numbered street grid (North of Glenoaks)
- Burbank Hills / Sunset Canyon
- The Verdugo foothill streets near Brace Canyon Park
Service Area – Cities Near Burbank
Tidewater Chimney Sweep serves Burbank and the surrounding communities. We also work in North Hollywood, CA, Glendale, CA, Studio City, CA, and Hollywood, CA. If you’re right on the edge of Burbank in one of these areas, call us at (866) 282-7014 and we’ll confirm coverage for your street.
Serving Burbank, CA – Our Local Coverage Area
We’re based in the Burbank area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Burbank
Most Burbank appointments are scheduled within one to three business days. We route our trucks through the San Fernando Valley and Burbank multiple days per week. For a cracked flue or active leak during heavy rain, we prioritize Burbank calls because the older housing stock means more damage when water gets in. Call (866) 282-7014 and we’ll find the soonest open slot that fits your repair.
Most chimney repairs we do, including flashing, cap replacement, crown work, and liner installation, don’t require a separate Burbank permit. A full teardown or rebuild might trigger the city’s building permit process. We’ll tell you during the estimate if your job will need city approval, and most Burbank homeowners only need our invoice and a camera report for their own records or a sale escrow.
Yes, we do pre-purchase chimney inspections throughout Burbank, and given the age of much of the housing stock here, it’s a smart call. We camera the full flue, check the firebox, crown, flashing, and cap, and write a report you can take to the seller or your agent. In Burbank’s 1920s-1950s neighborhoods, we’ve caught cracked liners and painted-over firebox damage in escrow inspections more times than we can count. Call (866) 282-7014 to book one.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you. The visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Burbank Customers Say
"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
- Mark Pruitt"Older house, weird setup, previous owner did some creative things. He didn't sigh or roll his eyes, he just figured it out. Took him a while but he got there."
- Steve Novak"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
- Cedric Whitfield